How to Activate Fiery / CADlink Software: SignLab, EngraveLab & Other CADlink Products
SignLab, EngraveLab and Other CADlink Products
This article provides a video reference for activating Fiery / CADlink software, including SignLab, EngraveLab, and other CADlink software products that use the same or similar activation process.
Although the demonstration may show a specific CADlink product, the general activation procedure applies to other CADlink software unless the license or software version provides different instructions.
Software Covered
This activation reference may be used for:
- SignLab
- EngraveLab
- Other Fiery / CADlink software using the same activation process
Note: Menus and screens may vary slightly depending on the software product and version.
Video: CADlink Software Activation
Use the following training video as a reference when activating your CADlink software:
Watch the Fiery / CADlink Software Activation Video
Important
The activation process shown in this video can also be used as a general reference for SignLab, EngraveLab, and other applicable CADlink software products.
Before Activation
Have the following ready:
- Installed Fiery/CADlink software
- Software license or activation information supplied with your purchase
- Internet connection, when required for activation
- Administrator access to the computer, if required
Make sure you are activating the correct CADlink product and license.
Activation
- Install and open the appropriate Fiery/CADlink software.
- Locate the software's licensing or activation function.
- Enter the license/activation information supplied with your purchase.
- Follow the on-screen activation prompts.
- Complete the activation process.
- Restart the software if prompted.
- Confirm that the software opens normally and recognizes the activated license.
Because interfaces can vary between SignLab, EngraveLab, and other CADlink versions, use the video as the primary visual reference and follow the prompts displayed by your specific software.
Troubleshooting
If activation is unsuccessful:
- Verify that the activation/license information was entered correctly.
- Confirm that the license corresponds to the installed CADlink product and version.
- Check the computer's internet connection.
- Restart the software and try again if appropriate.
- Record or take a screenshot of any activation error message.
If the issue continues, contact Jorlink Technical Support and provide:
- CADlink product name
- Software version
- License information as appropriate
- Computer/Windows version
- Screenshot or exact wording of the error
Additional Note for SignLab & EngraveLab Users
A dedicated SignLab or EngraveLab activation video may be added in the future. Until then, the linked CADlink activation video should be used as the general activation reference because the overall licensing workflow is similar across applicable CADlink products.